Adding/Editing A Qos Queue; The Class Setup Screen - ZyXEL Communications P-2612HNU-Fx User Manual

17.3.1 Adding/Editing a QoS Queue

Use this screen to configure a queue. Click the Add button or the edit icon in the
Queue Setup screen.
Figure 82 Advanced > QoS > Queue Setup: Add/Edit
The following table describes the labels in this screen.
Table 63 Advanced > QoS > Queue Setup: Add/Edit
LABEL
Active
Name
Priority
Weight
Rate Limit
Back
Apply
Cancel

17.4 The Class Setup Screen

Use this screen to add, edit or delete QoS classifiers. A classifier groups traffic into
data flows according to specific criteria such as the source address, destination
address, source port number, destination port number or incoming interface. For
example, you can configure a classifier to select traffic from the same protocol
port (such as Telnet) to form a flow.
P-2612HNU-Fx User's Guide
DESCRIPTION
Select to enable or disable this queue.
Enter the descriptive name of this queue.
Select the priority level (from 1 to 7) of this queue.
The smaller the number, the higher the priority level. Traffic assigned to
higher priority queues gets through faster while traffic in lower priority
queues is dropped if the network is congested.
Select the weight (from 1 to 15) of this queue.
If two queues have the same priority level, the ZyXEL Device divides the
bandwidth across the queues according to their weights. Queues with
larger weights get more bandwidth than queues with smaller weights.
Specify the maximum transmission rate (in Kbps) allowed for traffic on
this queue.
Click this to return to the previous screen without saving.
Click this to save your changes back to the ZyXEL Device.
Click this to begin configuring this screen afresh.
Chapter 17 Quality of Service (QoS)
227