Removing The Oil Filter; Installing The Oil Filter - KTM 250 EXC-F EU 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Removing the oil filter

x
13.109
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.

Installing the oil filter

x
13.110
–
Place a suitable container under the engine.
–
Remove screws
600687-10
–
Pull the oil filter insert
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean parts and sealing surface.
600688-10
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Fill oil filter
–
Lubricate O-ring
600689-10
–
Mount oil filter cover
–
Mount and tighten screws
Guideline
Screw, oil filter cover
–
Stand the motorcycle up.
600687-11
. Remove oil filter cover

out of the oil filter casing.

with engine oil and place it in the oil filter container.

of the oil filter cover.

.

.

with the O-ring.

M5 6 Nm (4.4 lbf ft)
89