MAINTENANCE WORK ON CHASSIS AND ENGINE
Adjusting the play of the steering head bearing
13.25
Removing the fork legs
13.26
(SX‑F, 250 EXC-F SIX DAYS EU)
x
–
Jack up the motorcycle. (
(250 EXC-F SIX DAYS EU)
–
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Fully tighten screws
800022-10
Guideline
Screw, top triple clamp
–
Mount and tighten screw
Guideline
Screw, top steering stem
(SX‑F)
–
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Fully tighten screws
600876-10
Guideline
Screw, top triple clamp
–
Mount and tighten screw
Guideline
Screw, top steering stem
–
Check the steering head bearing play. (
–
Remove front wheel.
–
Remove screws
(EXC‑F, EXC‑F SIX DAYS, XCF-W)
–
Remove cable clip
–
Remove screws
–
Hang the brake caliper and the brake line loosely to the side.
100802-10
(EXC‑F EU, EXC‑F AUS, XCF‑W ZA)
–
Loosen screws
–
Loosen screws
100804-10
p. 40)
. Remove screw
.
.
.
.
M8
. Remove screw
.
.
.
.
M8
p. 49)
(
p. 69)
x
and take off the clamp.
.
and take off the brake caliper.
. Remove the fork leg on the left.
. Remove the fork leg on the right.
M20x1.5
10 Nm
(7.4 lbf ft)
M8
17 Nm
(12.5 lbf ft)
17 Nm
Loctite
®
243™
(12.5 lbf ft)
M20x1.5
10 Nm
(7.4 lbf ft)
M8
17 Nm
(12.5 lbf ft)
Loctite
243™
17 Nm
®
(12.5 lbf ft)
50