MAINTENANCE WORK ON CHASSIS AND ENGINE
Adjusting the beam width of the headlight (EXC‑F, EXC‑F SIX DAYS, XCF-W)
13.78
Checking the headlight adjustment (EXC‑F, EXC‑F SIX DAYS, XCF-W)
13.79
A
0 0 A
Removing the seat
13.80
–
Refit the fuse.
Fuse (58011109110)
Info
A reserve fuse
Replace a burned-out fuse
If the new fuse burns out, contact an authorized KTM workshop.
–
Replace the protection cover.
400273-10
–
Install the air filter box lid. (
–
Check the headlight adjustment. (
–
Loosen screw
–
Adjust the light range by swiveling the headlight.
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with a rider (mark is applied under: Checking the headlight adjust-
ment).
Info
If you have a payload, you may have to correct the headlight beam width.
301251-10
–
Tighten screw
–
On a light-colored wall behind a horizontal area, make a mark as high as the center
of the headlight.
–
Make a second mark at distance of
Guideline
Distance
B
0 0 B
–
Stand the motorcycle upright in front of the wall at distance
protective clothing, should now sit on the motorcycle in a normal sitting position
(feet on the footrests).
Guideline
400726-10
Distance
–
Switch on low beam. Check the headlight adjustment.
The border between light and dark must be exactly at the lower mark when the
motorcycle is operational and complete with rider.
»
If the boundary between light and dark does not meet specifications:
–
Adjust the beam width of the headlight. (
–
Remove screw
above.
500080-10
is located in the starter relay.
only by an equivalent fuse.
p. 81)
p. 76)
.
.
under the first mark.
. Lift up the seat at the rear, pull it back and then remove from
5 cm (2 in)
. The driver, in full
5 m (16 ft)
p. 76)
76