Adjusting Chain Tension - Fitting Rear Wheel; Adjusting The Chain Guide (Exc-F, Exc-F Six Days, Xcf-W) - KTM 250 EXC-F EU 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Adjusting chain tension - fitting rear wheel

13.49
Adjusting the chain guide
13.50
–
Loosen nuts
–
Adjust the chain tension by turning the adjusting screws
Guideline
Chain tension
Turn the adjusting screws
right chain adjusters are in the same position relative to the reference marks
The rear wheel is then correctly aligned.
–
Tighten nuts
400225-11
(EXC‑F, EXC‑F SIX DAYS, XCF-W)
x
–
Remove screws
Condition
Number of teeth: ≤ 44 teeth
–
Insert nut
–
Mount and tighten screws
Guideline
Remaining screws, chassis
Condition
Number of teeth: ≥ 45 teeth
–
Insert nut
–
Mount and tighten screws
Guideline
Remaining screws, chassis
400252-10
.

left and right so that the markings on the left and

.

and . Take off the chain guide.
 
in hole . Position the chain guide.
 
and .
 
in hole . Position the chain guide.
 
and .
 
left and right.

8... 10 mm (0.31... 0.39 in)
M6 10 Nm
(7.4 lbf ft)
M6 10 Nm
(7.4 lbf ft)
60
.
