Topping Up The Front Brake Fluid - KTM 250 EXC-F EU 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Topping up the front brake fluid

13.57
Warning
Danger of accidents Failure of the brake system.
–
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding. (Your authorized KTM workshop will be glad to help.)
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Danger of accidents Reduced braking effect caused by old brake fluid.
–
Change the brake fluid of the front and rear brakes according to the service schedule. (Your authorized KTM workshop will
be glad to help.)
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never user DOT 5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid is corrosive!
Use only clean brake fluid from a sealed container!
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Check the brake fluid level in viewer
» If the brake fluid is below the MIN mark:
–
Top up the brake fluid of the front brake.
400231-10
x
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Add brake fluid to level
Guideline
Measurement of
Brake fluid DOT 4 / DOT 5.1 (
100395-10 –
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
.

.

with membrane .
 
.

5 mm (0.2 in)

p. 116)
x ( p. 63)
63