Adjusting Basic Position Of Clutch Lever; Checking The Fluid Level Of Hydraulic Clutch; Changing The Hydraulic Clutch Fluid - KTM 250 EXC-F EU 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE
–
Oil the dry air filter with a high/quality filter oil.
Oil for foam air filter (
–
Clean the air filter box.
–
Check carburetor connection boot for damage and tightness.
–
Install the air filter. (
x

Adjusting basic position of clutch lever

13.97

Checking the fluid level of hydraulic clutch

13.98
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Info
The fluid level rises with increasing wear of the clutch lining disc.
Avoid contact between brake fluid and painted parts. Brake fluid is corrosive!
Use only clean brake fluid from a sealed container!

Changing the hydraulic clutch fluid

13.99
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
p. 117)
p. 82)
–
Adjust the basic setting of the clutch lever to your hand size by turning adjusting
screw

Info
Turn the adjusting screw clockwise to increase the distance between the
clutch lever and the handlebar.
Turn the adjusting screw counterclockwise to decrease the distance between
the clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
500133-11
Do not make any adjustments while riding!
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Check the fluid level.
Fluid level under top level of container
» If the level of the fluid does not meet specifications:
–
Correct the fluid level of the hydraulic clutch.
400339-10
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt fluid immediately with water.
x
.
.

with membrane .
 
Brake fluid DOT 4 / DOT 5.1 (
4 mm (0.16 in)
p. 116)
83