Connect Sdi Signal Cable; Connect Ac Power Cord - Advantech PDC-190S User Manual

2.3.6

Connect SDI Signal Cable

Connect the BNC (75 ohms) cable to the SDI IN connector of the monitor. If you have
a loop-through requirement, please prepare another BNC (75 ohms) cable for con-
nection to the SDI OUT connector on the bottom of the SDI IN connector.
The IN connector is terminated internally at 75 ohms when nothing has been con-
nected to the output connector. If a cable is connected to the output connector, the
internal terminal is automatically released and the signal input to the input connector
is sent to the output.
2.3.7

Connect AC Power Cord

1. Insert the DC IN connector (DIN plug, type B) into the DC 12V IN connector on
the bottom of the monitor until it locks.
2. Plug the AC power cord (IEC-320, C13) into the AC IN socket (IEC-320, C14)
on the AC adapter.
Caution! An AC power cord is not included in the accessories list, please contact
local Advantech service if you need to purchase a local AC power cord.
3. Plug the AC power cord into AC outlet, then switch-on the power switch on the
side of AC adapter. The LED indicator turns green!
Caution! When you disconnect the cord/cables, be sure to hold the connector and
not the cable itself.
PDC-190S User Manual 12