Table of Contents
Advertisement
OSD Dura-
tion
OSD
Position
Factory
Reset
A.2
Main Menu Descriptions
The LCD monitor is capable of accepting both digital and analog signal inputs and
therefore has two different sets of OSD control functions. Since digital signaling
always gives optimal display quality without much adjustment, it requires fewer OSD
functions than the analog input mode. Those functions that are not available in the
digital input mode, e.g.: Auto Setup, Display, Clock/phase, etc., are denoted by an
asterisk (*)/(**) in the following descriptions. If selected while in digital input mode,
they will not be available.
A.3
Brightness Descriptions*
Selecting this control allows you to make adjustments to the luminosity level of the
display screen on a scale of 0 to 100.
Use the key on the front bezel to adjust the Brightness at any time the OSD is on.
Note!
This setting is only available on D-sub & video input, S-Video, compos-
ite, component/RGBS, SDI.
Figure A.1 Item Main Menu in OSD display
17
0- 5 sec.
1- 10 sec.
Adjust the time
2- 15 sec.
period for OSD
3- 20 sec.
menu disappear
4- 25 sec.
(Unit: second)
5- 30 sec.
6- 35 sec.
Adjusts position of
OSD
Load Default
PDC-190S User Manual
Advertisement
Table of Contents
