Fargo DTC550 User Manual page 410

FOR RESTRICTED USE only
Glossary of Terms (continued)
Term
Oversized Cards
Overlaminate
Parallel
Parallel Port
PC (Personal
Computer)
PCB (Printed Circuit
Board)
Peel
Peel-Off
Peripheral
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
Definition
Oversized cards are used for more efficient visual identification
and are available in many non-standard sizes. The most popular
sizes are CR-90 (3.63" x 2.37"/92mm x 60mm) and CR-100 (3.88"
x 2.63"/98.5mm x 67mm).
Protective clear or holographic material to increase security and
durability applied over the printed surface with a hot Roller.
A method of data transfer in which serial data is divided into
sections and sent simultaneously down parallel wires to speed
transfer rate.
A communication socket on a device that allows for parallel data
transfer.
A stand-alone, programmable, electronic device that can store,
retrieve and process data consisting of a CPU, mouse, keyboard
and monitor.
A solid, multi-layered plate on which electronic elements are
attached, either through the board or on the surface.
The removal of a film or Ribbon from a card surface (at a
perpendicular angle) to ensure proper transfer, then separation,
from the card surface.
A bar on the lamination section that holds the film at the correct
position and provides proper peel angle.
Any device that is attached externally to a PC. These often share
the same data cable or port as a Printer and can be the source of
communication problems.
Fargo Electronics, Inc.
Continued on the next page
14-13