Fargo DTC550 User Manual page 177

FOR RESTRICTED USE only
Performing the procedure for the DTC550 Card Lamination Module
Attachment Kit (continued)
Step Procedure
9 If you have not already done so, install the Laminator version of your Printer
model's Printer Drive.
For lamination-related Printer Driver options, see the
tab (only with Card Lamination
For overlaminate information, see the
Loading the
The packaging for the Card Lamination Module has been designed to
accommodate shipping either the Lamination Module-only or the fully
assembled Printer with Lamination Module.
After assembling the complete Printer/lamination system, please re-use the
Lamination Module packaging when transporting the unit.
10 Connect the plug from the power supply to the Card Lamination Module.
(Note: There are two power supplies to the DTC550 Direct to Card
Printer/Encoder with Laminator. There is one power supply to the Printer,
and one power supply to the Card Lamination Module.)
11 Installation of the field upgradeable Card Lamination Module is now
complete.
• If you have not already done so, install the LC version of your Printer
model's Printer Driver.
• Refer to the included DTC550 Quick Start Sheet for instructions on
installing the Printer Driver and on loading the print ribbon, cards, and
overlaminates.
• For complete overlaminate information, please refer to the Online User's
Guide which installs from the Software Installation CD.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
Module).
Overlaminate.
Fargo Electronics, Inc.
Using the Lamination
Reviewing the Overlaminates and
5-16