Fargo DTC550 User Manual page 113

FOR RESTRICTED USE only
Troubleshooting the LCD Messages (continued)
LCD Message
INVALID RIBBON
2
INVALID RIBBON
3
JOB DATA ERROR The print data sent to the
LAM CARD FLIP
ERROR
LAM ERROR
LAM HANDLER
STARTUP
LAM LIFT ERROR
LAM MATERIAL
LOW
LAM MEMORY
ERROR
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
Cause
The print Ribbon installed
in the Printer does not
match the Ribbon type
set in the Printer.
The print Ribbon installed
in the Printer does not
match the Ribbon type
set in the Printer.
Printer is corrupt or has
been interrupted.
A problem has been
detected in the Laminator
flipper.
The Lamination module
requires attention.
See the next column.
See the next column.
Lamination material is
low.
See the next column.
Fargo Electronics, Inc.
Solution
Get the correct Ribbon from your
dealer. See the Resolving the
Wrong Print Ribbon Error
Message.
Get the correct Ribbon from your
dealer. See the Resolving the
Wrong Print Ribbon Error
Message.
Check the interface cable and
cancel the print job from the PC.
Press CANCEL to abort this print
job and then resend the job.
If this problem persists, call for
technical assistance.
Check the indicated condition and
correct it, using the Laminator's
control buttons. Press QUIT to
clear this message.
If this problem persists, call for
technical assistance.
If this problem persists, call for
technical assistance.
If this problem persists, call for
technical assistance.
4-8