Fargo DTC550 User Manual page 115

FOR RESTRICTED USE only
Troubleshooting the LCD Messages (continued)
LCD Message
OPEN PRINT ARM
PANEL STARTUP
ERROR
PLEASE REMOVE
CARD
PLEASE REMOVE
RIBBON
PRINT RIBBON
LOW
PRINT RIBBON
OUT
REINSERT
RIBBON
RIBBON ALIGN
ERROR
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
Cause
Cover and print arm must
be opened for Printer
cleaning.
A problem has been
detected in the print
section of the Printer
during start-up.
Exception recovery
cannot position a card
located in the Printer.
See the next column.
The print Ribbon will soon
run out.
The print Ribbon has run
out.
The Ribbon must be
reinserted for proper
functioning of the Printer.
The print Ribbon is either
damaged or the Printer is
not calibrated.
Fargo Electronics, Inc.
Solution
Open cover and print arm and
retry.
If this problem persists, call for
technical assistance.
Please remove or reposition the
card and press RESUME to
continue.
The Ribbon must be removed at
this point to properly calibrate the
Sensor.
If printing a large number of cards
replace the Ribbon now or monitor
the Printer until the Ribbon is gone
and install a new Ribbon.
Install a new Ribbon and press
RESUME to continue or CANCEL
to abort.
Reinsert the Ribbons or press
RESUME.
Replace the Ribbon or recalibrate
according to the steps in the
Troubleshooting section of the
User Guide. Press RESUME to
continue or CANCEL to abort. See
Resolving the Ribbon Alignment
Error Message.
4-10