Removing The Card Jam In The Printer's Smart Card Encoding Area - Fargo DTC550 User Manual

FOR RESTRICTED USE only
Removing the Card Jam in the Printer's Smart Card Encoding
Area
Symptom: A card is jammed in the Smart Card encoding area of the Printer.
Step Procedure
1 Clear the jammed card.
a. Open the Top Cover and the Printhead Arm.
b. Use the arrows on the LCD panel to move the card forward or
backward to free the card.
2 Inspect the Card Feed Roller Motor for proper operation.
a. Leave the power ON and open the Top Lid and Printhead Arm.
b. Press the FWD button to advance the card or the REV button to
reverse the card. (Note: Use these buttons to move the card through
the Printer.)
3 Adjust the Flipper Offset.
a. Select Menu on the LCD display.
b. Select Setup Printer
c. Select Flipper Offset.
d. Select Encoder Flip Angle
e. Change the setting in small increments. (Note: A negative adjustment
will lower the side of the Flipper Table closest to the Exit Hopper.)
f. Press Done. When it asks if you want to save, press Yes.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
Fargo Electronics, Inc.
4-25