Fargo DTC550 User Manual page 146

FOR RESTRICTED USE only
Resolving the Card surface debris problems (continued)
Step Procedure
3 Replace the Cleaning Roller.
Open the Printer's Top Cover.
Pull the Cleaning Cartridge out of the Printer.
Remove the old roller from the Cleaning Cartridge and replace it with the
new roller.
Pull on the Cleaning Roller's tab to remove the backing from the tape.
Insert the Cleaning Cartridge back into the Printer.
Caution: Be sure to push down on the cartridge until it clicks into
place.
4 Clean the Platen Roller.
Leave the Printer power ON and open the Top Cover and Printhead Arm.
Remove the Print Ribbon.
Locate the Platen Roller.
Use a Cleaning Pad from the Printer Cleaning Kit to wipe the Roller clean.
Press the FWD and REV buttons to move the Roller back and forth while
cleaning.
Replace the Print Ribbon and close the Top Cover and Printhead Arm after
the Rollers are clean and completely dry.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
Fargo Electronics, Inc.
4-41