Configuration Examples - NEC N8100-1005F User Manual

Configuration Examples

The following describes examples of configuration required to use software-link features or for
system operations.
Time and Date Settings
You can also change the time and date settings via the operating system commands.
Select [Main] - [System Time].
Select [Main] - [System Date].
Link with Management Software
To control power supply of the server with NEC ESMPRO Manager via the network
Select [Advanced] - [Advanced Chipset Control] - [Wake On LAN/PME] - [Enabled].
Select [Server] - [AC LINK] - [Stay Off].
ATA Drive Settings
To check the ATA drives connected with the onboard ATA channels.
Select [Main] - [Primary IDE Master], [Primary IDE Slave], [IDE Secondary/Master], and
[IDE Secondary/Slave].
To configure the RAID drive.
Select [Advanced] - [I/O Device Configuration] - [SATA Controller Mode Option] -
[Enhanced] - [SATA RAID Enabled], [Enabled], and use the RAID configuration utility
(see "RAID Configuration Utility" in this chapter).
UPS
To link power supply with the UPS
To power on the server when power is supply from the UPS
Select [Server] - [AC LINK] - [Power On].
To keep the server off-powered even when power is supplied from the UPS
Select [Server] - [AC LINK] - [Stay Off].
Configuring Your Server 4-5