NEC N8100-1005F User Manual page 189

Error
Error message
code
02D1 System Memory exceeds the CPU's caching limit.
02F4 EISA CMOS not write able.
02F5 DMA Test Failed.
02F6 Software NMI Failed.
02F7 Fail-safe Timer NMI Failed.
0B22 Processors are installed out of order.
0B28 Unsupported Processor detected on Processor 1. Make sure that the server supports the
0B30 Fan 1 Alarm occurred.
0B31 Fan 2 Alarm occurred.
0B32 Fan 3 Alarm occurred.
0B5F Forced to use Processor with error
0B60 DIMM group #1 has been disabled
0B61 DIMM group #2 has been disabled
0B62 DIMM group #3 has been disabled
0B63 DIMM group #4 has been disabled
0B70 The error occurred during temperature sensor
reading.
0B71 System Temperature out of the range.
0B74 The error occurred during voltage sensor reading.
0B75 System voltage out of the range.
0BB0 SMBIOS – SROM data read error.
0BB1 SMBIOS – SROM data checksum bad.
8100 Memory Error detected in DIMM group #1.
8101 Memory Error detected in DIMM group #2.
8102 Memory Error detected in DIMM group #3.
8103 Memory Error detected in DIMM group #4.
None Expansion ROM not initialized – PCI Mass
Storage Controller in slot n (n: slot number)
Troubleshooting 8-9
Recommended Action
Contact your service representative.
Request the maintenance to replace the
CPU.
CPU. If you are not sure, contact your
service representative to request the
maintenance.
Contact your service representative to
replace the fan.
Because an error is detected in every
CPU, the system is forcibly started.
Contact your service representative.
Contact your service representative.
Contact your service representative.
Contact your service representative to
replace the fan.
Contact your service representative.
Contact your service representative to
replace the DIMM in the relevant group.
Disable initialization of the optional
device expansion ROM by using the
BIOS SETUP utility (see Chapter 4).