NEC N8100-1005F User Manual page 243

8.
Gently push the levers to the upright position until they engage the notches in the DIMM.
9.
Install the remove components.
10.
When Windows Server 2003 or Windows 2000 is used, set the paging file size to the
recommended value or larger.
Installed memory capacity × 1.5 for Windows 2000 (See Chapter 5.)
Removal
Remove the DIMM depending on the following procedure.
NOTES:
To remove the defected DIMM, check the error message appearing
in POST or NEC ESMPRO to identify the DIMM socket (group) in
which the defected DIMM is installed.
The server operates only when at least one DIMM is installed.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Remove the left side cover as described earlier in this chapter.
3.
Expand the levers at the both ends of the socket for the DIMM to be removed leftward or
rightward
The lock is released to allow the DIMM to be removed.
4.
Install the components removed in step 2.
5.
When Windows Server 2003 or Windows 2000 is used, set the paging file size to the
recommended value or larger.
Installed memory capacity × 1.5 for Windows 2000 (See Chapter 5.)
Upgrading Your Server 9-33