When You Fail To Eject - NEC N8100-1005F User Manual

IMPORTANT:
setting of a CD-ROM, reload the CD-ROM.
To remove a CD-ROM, press the Open/Close button to eject the tray, as described for inserting it,
and then take the CD-ROM out of the tray. (The orange-lit access lamp indicates ongoing disk
access. The Open/Close button does not work while the lamp is lit.)
Your OS may have a command to eject the tray.
When you have taken out the CD-ROM, retract the tray back in place.

When you fail to eject:

When you fail to eject the CD-ROM tray with the Open/Close button and take out the CD-ROM
from the server, follow the procedure below.
1.
Press the POWER switch to power off the server. (The POWER/SLEEP lamp goes off.)
2.
Insert a metal pin of approximately 1.2 mm in diameter and 100 mm in length (a
straightened large paper clip will make a substitute) into the emergency hole on the right
front of the CD-ROM drive and gently push it in until the tray is ejected.
IMPORTANT:
Do not use a toothpick or plastic stick that is easy to break.
If the above procedure does not let you take out the CD-ROM,
contact your sales agent.
3.
Hold the tray and pull it out.
4.
Take out the CD-ROM.
5.
Push the tray back into position.
If the CD-ROM drive produces large noise after the
General Description 2-21