Front Mask
The front mask must be removed to install or remove the hard disk drive and 5.25-inch device.
IMPORTANT:
static precautions described in this chapter before proceeding the
procedures described here.
Removal
Follow the procedure below to remove the front mask.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Remove the left side cover as described earlier in this chapter.
3.
Pull the release tabs (3) at the left end of the front mask toward you so that the tabs are
removed from the frame of the server.
IMPORTANT:
hooks fixing the right end of the front mask will be damaged. Only pull
out the tabs a little.
4.
Remove the front mask to the left to release the tabs on the front mask from the chassis.
Observe safety precautions described in Chapter 1 and
If the tabs are pulled out toward you excessively, the
Upgrading Your Server 9-9