Table of Contents
Advertisement
Chapter 4
Configuring Your Server
Configuration and setup utilities are used to change your system configuration. You can configure
your system, as well as option boards you may add to your system, using the BIOS Setup utility.
Several unique system parameters are configured using the BIOS Setup utility, which is stored in
the system FLASH memory.
The Array Configuration Utility (ACU) controls the serial ATA hard disk drives as a RAID drive.
Use this utility if you need to configure the RAID drive with the serial ATA hard disk drives or to
perform a RAID disk format or verify disk operation on the serial ATA disk drives. The Array
Configuration Utility is used only for the serial ATA hard disk drives that are connected with the
serial ATA channel on your server board.
If your system has been factory configured, the BIOS Setup utility or Array Configuration Utility do
not need to be run unless you want to change the password or security features, add certain types of
option boards or devices, or upgrade your mother board.
This chapter also provides information on several system configuration parameters that are set by
jumpers on the system board. However, these parameters do not usually require change.
Use NEC EXPRESSBUILDER CD-ROM to create the device driver diskettes.
Advertisement
Table of Contents
Troubleshooting
