1000/100/10 Lamp; Hard Disk Drive Lamp (Disk Lamp) - NEC N8100-1005F User Manual

1000/100/10 Lamp

The 1000/100/10 lamp indicates whether each of the network ports normally equipped with the
server is operated through the 1000BASE-T, 100BASE-TX or 10BASE-T network interface. If
the lamp is lit orange, the network port is operated through 1000BASE-T. If the lamp is lit green,
the network port is operated through 100BASE-TX. If the lamp is off, the network port is operated
through 10BASE-T.

Hard Disk Drive Lamp (DISK Lamp)

The optional hot-swap SCSI hard disk drive bay can contain three 1-inch height SCSI hard disk
drives. Each hard disk drive has a DISK lamp on its front panel.
The DISK lamp indicates the drive status as follows.
Lighting green
The hard disk is installed and powered on.
Blinking green
Indicates that the hard disk is accessed.
Lighting amber
Indicates that the installed hard disk is defected in the disk array configuration.
NOTE:
(RAID1/RAID5 or RAID0+1), a single failed hard disk does not affect
the operation of the server. However, it is recommended to replace the
failed hard disk and auto-rebuild (reconfigure) the hard disks as soon as
possible. (You can hot-swap such a failed hard disk.)
While hard disks are in the disk array configuration
Troubleshooting 8-5
DISK lamps