Configuring Your Server - NEC N8100-1005F User Manual

4-22 Configuring Your Server

See the table below for the items.
Option
User Password Is
Supervisor
Password Is
Set User
Password
Set Supervisor
Password
Password on boot
Fixed disk boot
sector
Diskette access
Parameter
Clear
Set
Clear
Set
Up to eight
alphanumerics
Up to eight
alphanumerics
[Disabled]
Enabled
[Normal]
Write Protect
User
[Supervisor]
Description
Status only, user cannot modify.
Once set, this can be disabled by
setting it to a null string, or by clearing
password jumper on system board
(see Configuring Mother Board
Jumpers in this Chapter).
Status only, user cannot modify.
Once set, this can be disabled by
setting it to a null string, or by clearing
password jumper on system board
(see Configuring Mother Board
Jumpers in this Chapter).
Supervisor password controls access
to the setup utility.
When Enter is pressed, the user is
prompted for a password; press Esc
to abort. Once set, this can be
disabled by setting it to a null string, or
by clearing password jumper on
system board (refer to Configuring
Mother Board Jumpers in this
chapter).
When the <Enter> key is pressed, the
user is prompted for a password;
press ESC key to abort. Once set, this
can be disabled by setting it to a null
string, or by clearing password jumper
on system board (refer to Configuring
Mother Board Jumpers in this
chapter).
Disables or enables password entry
on boot.
Will write protect the boot sector of the
hard drive to prevent viruses from
corrupting the drive under DOS if set
to write protect.
Controls access to the floppy disk
drive.
Your Setting
[ ]: Factory-set