NEC N8100-1005F User Manual page 239

Removal
Remove the board connected to the PCI board slot in the following procedure.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Remove the left side cover.
3.
Remove the PCI board retention springs following the installation steps 4 and 5.
4.
Remove the board.
5.
Install the additional slot cover and then install the PCI board retention springs following
the installation steps 8 and 9.
6.
Assemble the server.
7.
Turn on the power of the server. Make sure that no error message appears in the POST.
If an error message appears, write down the message and contact the maintenance service
agent for the maintenance.
Upgrading Your Server 9-29