Installation
AC Input Power Connection
3. Slide the helix-shaped body onto the AC cable. Insert the stripped wires through
4. Route the AC wires to the input connector terminals as required. For input
5. Route the wires inside the cover to prevent pinching. Fasten the AC input cover
Assembled
Strain Relief
Flat Washer (2 places)
Lock Washer (2 places)
Screw (2 places)
Figure 2.2 AC Input Cover and Strain Relief
42
the strain relief base until the outer cable jacket is flush with the edge of the base.
Tighten the body to the base while holding the cable in place. The cable is now
securely fastened inside the strain relief.
connector terminal locations, see lower inset in Figure 2.2. To connect the
wiring, loosen the terminal screw, insert the stripped wire into the terminal, and
tighten the screw securely.
to the unit using the 6-32 x 1 1/4 in. (2) screws, flat washers, and lock washers
provided. See Figure 2.2.
Cover
Operating Manual for XFR 1.2kW Series Power Supply
Stripped Wire Installed in Strain Relief
Connector Terminal Locations
Screw-on
Locknut