Xantrex XFR 6-200 Operating Manual page 77

5. Set the programming sources to the desired levels and turn the power supply ON.
Please remember:
1. Any of the eight switches on SW1 is OFF (OPEN) when it has been flipped up
2. Resetting switches SW1-3 or SW1-4, the programming scale selection switches,
3. Switches SW1-5, SW1-6, SW1-7, and SW1-8 are not required for remote
4. Switches SW-1 to SW-4 can be set to their defaults (1 and 2 open, 3 and 4 closed)
5. The control circuits have been designed to allow you to set output voltage and
Release 3.1
The REM LED turns on. Adjust the external programming source to change the
power supply's output.
to break contact, ON (CLOSED) when flipped down to close contact.
may require that you recalibrate the programming circuit to maintain
programming accuracy. See Section 5. Calibration.
programming. They remain at the settings you have selected for your
application.
unless otherwise specified in Table 4.2. See "Rear Panel SW1 Switch" on page
19 for default settings.
current up to 5% over the model-rated maximum values. The power supply will
operate within these extended ranges, but we cannot guarantee full performance
to specification.
Remote Analog Programming of Output Voltage and Current Limit
Remote Operation
75