Connecting More Than One Scsi Library - ADIC SCALAR 24 Installation And Operation Manual

2 Connect the free end of the SCSI cable to the connector on the host computer's SCSI adapter.
3 If you wish to connect one or more additional devices to the bus after the Scalar 24, connect an
appropriate cable between the remaining SCSI connector on the rear panel of the Scalar 24 and the
next device.
4 Terminate the last device in the chain.
Ensure that you are using the proper terminator for your type of SCSI
CAUTION
device. Terminators should be SPI-3 compliant.
5 Make sure that the SCSI cable between the host adapter and the Scalar 24 is secure and the
connections are fastened correctly.

Connecting More than One SCSI Library

If you are connecting more than one Scalar 24 on the same SCSI channel, connect each unit to the previous
unit with an additional shielded interface cable. It does not matter which SCSI connector on each Scalar 24
you connect the interface cable to. Make sure that you configure each Scalar 24 unit with a unique drive
SCSI ID and library ID. Your Scalar 24s will not function properly if they have the same SCSI IDs. For more
information on setting SCSI IDs, refer to
Scalar 24 Installation and Operation Guide
SCSI/Fibre on page 77.
15