Configure Slots - ADIC SCALAR 24 Installation And Operation Manual

Selection
2 Press to begin using the Wizard.
3 Press and to select the
configuration of the I/E slot.
insert graphic
4 Press and then
changes and move to the next option.
5 Press and to enable/disable
partitioning.
62
Description/Result
Available options are:
• Import/Export: host sees one import/export
• Storage: appears as a valid storage
Recommended: Import/Export
to accept the
Available options are:
• on: library is split into two partitions. The
• off: host sees entire library
Recommended: off
If you want to use partitioning, configure it
using the Config Slots submenu. For more
information, refer to
70.
If you enable partitioning through the Setup
Wizard, set the items shown in
Step
slot and 23 data slots for LTO or 20 data
slots for SDLT.
location to the host application (host sees 24
data slots). If partitioning is enabled, this slot
is in Partition 1.
host is affected (reduced slot/drive count)
based on which partition it is attached to.

Configure Slots

16.
on page
Step 12 through
Using the Menus