Connecting The Power Cord; Inserting Tape Cartridges - ADIC SCALAR 24 Installation And Operation Manual

Connecting the Power Cord

Follow the procedure below to connect the power cord to your Scalar 24.
1 Make sure the power switch on the front of the library is off (the
USE CAUTION WHEN PLUGGING THE POWER CORD INTO AN
WARNING
ELECTRICAL OUTLET. HAZARDOUS VOLTAGES ARE PRESENT IN
THE SOCKETS OF THE OUTLET.
2 Plug the power cord into the AC receptacle on the rear panel of your Scalar 24.
Ensure that the AC line cord from the library is plugged directly into
CAUTION
the socket. Extension cords should not be used.
3 Plug the power cord from the Scalar 24 into a grounded electrical socket.

Inserting Tape Cartridges

Make sure that the write-protect switch is set appropriately on each cartridge. Slide the switch to the
appropriate position by pushing it with your finger.
Follow the procedure below to insert data cartridges.
1 Open the media access door.
Scalar 24 Installation and Operation Guide
is pressed).
17