Getting Started; Unpacking And Inspecting; Checking The Accessories - ADIC SCALAR 24 Installation And Operation Manual

This section describes how to install and set up the Scalar 24. The steps involved in installation include:
•

Unpacking and inspecting

•

Checking the accessories

• Installing Scalar 24 hardware
• Setting up your Scalar 24 library
• Preparing the host computer
Unpacking and Inspecting
Unpack all items from the carton. Save the packing materials in case you need to move or ship the system
in the future.
You must ship the Scalar 24 in the original or equivalent packing
CAUTION
materials or your warranty may be invalidated.
Use the link on the Scalar 24 Documentation and Software CD to register the product. The serial number is
available through the operator panel and is also on the inside your Scalar 24, below the right magazine. In
order to see the serial number label, remove this magazine.
Checking the Accessories
Check to make certain that the following items are included with your Scalar 24 and that none of them are
damaged:
• US power cord
• European power cord
• One 1-foot SCSI cable (dual drive version only)
• Active 68-pin SCSI bus terminator
• Two keys for the front door
• Scalar 24 Documentation and Software CD
• Quick Start Guide
Scalar 24 Installation and Operation Guide

Getting Started

13