Table of Contents
Advertisement
Finally, the terminal will dial the Host computer to report the
successful installation.
Installation is now complete and the terminal will display the READY prompt. Your terminal is now
ready for use. Check the date and time on your terminal, if this needs to be corrected refer to Section
31 of this guide for details on how to do this
5.
Using the Terminal
Switching the Terminal On and Off
To SWITCH ON the terminal when it is off the base, press:
If on the base the terminal will always be powered.
To SWITCH OFF the terminal, press the yellow CLEAR button and
The Terminal Display
The terminal has a colour display and the icons in the banner at the top of the display use colour to
indicate their status.
Signal Strength and
Assigned Base
This will indicate the signal
strength (see section below
'Connection Information')
6.
Battery Information
Your terminal is supplied with a removable, rechargeable
battery. This battery recharges when the terminal is
connected to the charger unit.
Following installation, the battery charge status is
indicated by the battery icon found in the top right hand
corner of the terminal display.
When you charge the battery for the first time, it should be
charged until full capacity is indicated. This may take from
4 to 16 hours. New terminals are dispatched with some
charge present. Transactions can be performed providing
the terminal is connected to the charger unit so that it can
continue charging.
One of these Battery Status Symbols will be displayed depending on the charge in the battery and
whether the handset is on the Base.
If the terminal is on the base unit the battery symbol will display a power cord from the bottom of the
battery.
.
READY
Merchant Number
12345678
READY
Merchant Number
12345678
at the same time
Battery Charge Indicator
This will indicate the
amount of battery charge
(see section below
'Battery Information')
Battery low
Battery fully
charged (off base)
Page 7
Hide quick links:
Advertisement
Table of Contents
