Ingenico EFTBEMi Quick Start Manual

Quick Start Guide - Ingenico EFTBEMi

Getting Started

Set up the terminal in a convenient location.
Plug the power
socket, and the phone lead into the
on the base unit. Press the
the terminal.
After a short initialisation process the main idle screen
will be displayed, the terminal now ready to use.
NB: Press and hold the yellow key and the key
together to turn the terminal off .
SUPERVISOR PASSWORD:
01483
NB: You should change this password.
F1-F4 Keys:
These four function keys enable you
1
to choose the options on screen and correspond to
the to labels displayed on screen.
MENU Key:
To enter the application menus press
2
the key from the idle screen. Pressing the key
again moves to the next menu (if available).
Correction Keys:
3
the yellow key deletes one character at a time,
while the red
key also cancels transactions.
OK Key:
4 The green
that has been typed into the terminal.
Power/Feed Key:
5
through the printer press the
for instructions to change the paper rolls.
The Chip Card Reader
Customer cards must be inserted as shown, with the
chip upwards. Push the card fully into the slot below
the keypad and follow the instructions on screen.
If you see a BAD READ message, check the card
orientation and try again. After three bad reads
the terminal will prompt you to swipe the card.
DO NOT remove the card until instructed to do so
by the terminal.
supply unit into the
key once to turn on
When entering numbers or letters,
key deletes the entire line. The
key is used to confi rm anything
To test the feeding of the paper
See page 4
key.
power
socket
The default Supervisor Password is 01483.
5
1 1
2
3
4