How To Test The Signal Quality - Ingenico EFT930G User Manual

35. How to Test the Signal Quality

You should make every effort to retain a high signal strength when using the terminal; signal strength
is indicated by this symbol on your terminal display:
To test the signal strength please proceed as instructed below. This will allow you to determine if you
have any bad reception areas.
Note: A good reading is 255 and a low reading would be 180. Try to achieve a reading between 200
and 255.
1. At the READY prompt, press the MENU button twice.
Using the arrow button select the Select Function option
and then press the GREEN button.
2. Enter the number 36 and then press the GREEN button.
3. Swipe the Supervisor Card or key in Supervisor code.
4. Using the arrow button select the Test Radio Link
option.
5. To start the test press the GREEN button. If not, press the
RED button to abort the test procedure.
6. The signal test will run for 60 seconds and print the result.
If the result is low (ie. 180) move the base to a different
location and run the tests again. Press CANCEL to quit the
testing and Return to the READY prompt.
SYSTEM MENU
Totals
Print Function Codes
Select Function
Key in Function Code
and then press ENTER
Signal Quality Test
Press ENTER to start
or CANCEL to quit
Signal Quality Test
Running
xx seconds remaining
press CANCEL to quit
Signal Quality Test
Press ENTER to start
or CANCEL to quit
Page 33