Advanced Setting > Snmp - NetComm N3G001W User Manual

3g wireless router

Hide thumbs Also See for N3G001W:

Table of Contents

Advanced Setting > SNMP

SNMP (Simple Network Management Protocol) is a protocol designed to give user the capability to remotely

manage a computer or network device by polling and setting terminal values and monitoring network events.

To Enable SNMP, you need to set the following:

•

Enable SNMP. Check either Local or Remote or both to enable the function. If Local is ticked, the unit will

respond to request from LAN and if Remote is ticked, the unit will respond to request from WAN.

•

Get Community. Set the community for GetRequest. This will act as a password.

•

Set Community. Set the community for SetRequest. This will act as a password.

•

IP 1,IP 2,IP 3,IP 4. Input the IP addresses of your management PCs. The unit will send SNMP Trap

message only to the IP address listed.

•

SNMP Version. Select the SNMP version of your SNMP Management software.

Click Save to save the settings and Undo to cancel.

YML869 Rev1

www.netcomm.com.au

N3G001W 3G Wireless Router User Guide

Table of Contents