Table of Contents
Advertisement
SNMP
The SNMP page is used to configure the SNMP features of the router.
SNMP (Simple Network Management Protocol) is used to remotely monitor the router for conditions that may warrant administrative
attention. It can be used to retrieve information from the router such as the signal strength, the system time, the interface status,
etc.
To configure SNMP:
1.
Select the "Enable" option for the Enable SNMP field.
2.
Enter the Community Names or leave them as default.
Community names are used as a type of security to prevent access to reading and/or writing to the routers configuration. It
is recommended to change the Community names to something other than the default when using this feature.
3.
Click the "Save" button to save the new settings.
ITEM
Trap Destination (IP Address)
Heartbeat Interval (seconds)
Trap Persistence Time (seconds)
Trap Retransmission Time (seconds)
You can also trigger an SNMP Heartbeat manually by clicking the "Send Heartbeat Now" button.
NTC-30WV – Outdoor HSPA+ WiFi Router with Voice
56
Figure 59 - SNMP Settings
The IP Address SNMP data is to be sent to.
The number of seconds between SNMP heartbeats.
The length of time an SNMP trap persists.
The length of time between SNMP trap retransmissions.
Table 28 - SNMP Configuration Options
DEFINITION
www.netcommwireless.com
Advertisement
Table of Contents
