Front I/O Assembly - HP Pro 2110 Small Form Factor Maintenance & Service Manual

Front I/O Assembly

The front I/O assembly is attached to the front of the chassis. Pull the assembly away from the chassis
to remove it.
1.
Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Remove the system fan
5. Disconnect the front audio and front USB cables from the yellow and white system board
connectors.
6.
Remove the cables from the clips on the base of the computer.
Figure 6-30
(Preparation for Disassembly on page
(Access Panel on page
(Front Bezel on page
(System Fan on page
Front I/O assembly cable clip locations
88).
89).
103).
87).
Front I/O Assembly 117