System Board - HP Pro 2110 Small Form Factor Maintenance & Service Manual

Table 5-11
Japan
Latin America

System Board

When replacing the system board, be sure that the following components are removed from the
defective system board and installed on the replacement system board:
Memory modules
●
Processor
●
Expansion cards
●
To remove the system board:
1. Prepare the computer for disassembly
2.
Remove the access panel
3.
Lay the computer on its side with the rear facing toward you.
4.
Remove the front bezel
5.
Remove an expansion cards
6.
Disconnect the power, and data cables from the back of all installed drives.
7.
Disconnect all cables from the system board.
8. Remove the eight screws that secure the system board to the chassis (1).
82 Chapter 5 Removal and Replacement Procedures Minitower (MT) Chassis
Country power supply settings (continued)
115W
115W
(Access Panel on page
(Front Bezel on page
(Expansion Cards on page
The United Kingdom
The United States
(Preparation for Disassembly on page
43).
44).
54).
230W
115W
42).