HP Pro 2110 Small Form Factor Maintenance & Service Manual page 128
Hide thumbs
Also See for Pro 2110 Small Form Factor:
- User manual (86 pages) ,
- Specification (12 pages) ,
- Illustrated parts & service map (4 pages)
Table of Contents
Advertisement
7.
Disconnect the hard drive activity LED connector from rest of the power switch cable bundle.
Figure 6-31
8.
Remove the screw that secures the assembly to the front of the chassis (1).
9.
Slide the assembly up and pull it away from the front of the chassis while threading the wires
through the hole in the chassis (2).
Figure 6-32
To install the front I/O assembly, reverse the removal procedure.
NOTE:
Be sure to correctly route the cables when reinstalling the assembly. Proper cable routing
prevents damage to the cables and promotes proper air flow.
118
Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
Disconnecting the hard drive activity LED
Removing the front I/O assembly
Advertisement
Table of Contents
