Front I/O And Usb Panel Housing Assembly - HP Pro 2110 Small Form Factor Maintenance & Service Manual

Front I/O and USB Panel Housing Assembly

1.
Prepare the computer for disassembly
2. Remove the access panel
3.
Lay the computer on its side with the front facing toward you.
4.
Remove the front bezel
5.
Unplug the two cables from the yellow and white system board connectors on the system board.
6.
Remove the screw that secures the housing to the chassis, and then pull the assembly away from
the chassis while guiding the cables through the hole in the chassis.
To install the housing assembly, reverse the removal procedures.
When installing the assembly, note that the assembly has hooks that fit into slots in the chassis, as
shown in the following images.
72 Chapter 5 Removal and Replacement Procedures Minitower (MT) Chassis
(Preparation for Disassembly on page
(Access Panel on page
(Front Bezel on page 44).
43)
42).