Front I/O Assembly - HP EliteDesk 705 G2 Small Form Factor Maintenance And Service Manual

Front I/O assembly

The front I/O assembly is attached to the front of the chassis with one screw. Push the assembly into the
chassis to remove.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Rotate the drive cage to its upright position.
5. Disconnect the cables from the system board as follows:
(1) Yellow connector labeled FRONT_USB
(2) Blue connector labeled FRONT AUD
(3) Blue connector labeled FRONT_USB3.0
6. Remove the cables from the three clips built into the basepan (4).
7. Remove the Torx T15 screw (1) that secures the assembly to the front of the chassis.
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 20).
20).
19).
Front I/O assembly 51