Hp Pro 3120 - Computer Setup (F10) Utilities; Using Computer Setup (F10) Utilities - HP Pro 2110 Small Form Factor Maintenance & Service Manual

HP Pro 3120 – Computer Setup (F10) Utilities
Use Computer Setup (F10) Utility to do the following:
Change factory default settings.
●
Set the system date and time.
●
Set, view, change, or verify the system configuration, including settings for graphics, audio,
●
storage, communications, and input devices.
View settings for processor and memory.
●
Modify the boot order of bootable devices such as hard drives, optical drives, or USB flash media
●
devices.
Run hard drive self-tests.
●
Establish a supervisor password that controls access to Computer Setup (F10) Utility and the
●
settings described in this section.

Using Computer Setup (F10) Utilities

Computer Setup can be accessed only by turning the computer on or restarting the system. To access
the Computer Setup Utilities menu, complete the following steps:
1. Turn on or restart the computer.
2. As soon as the computer is turned on, press
system to enter Computer Setup.
NOTE:
press F10
3. The Computer Setup Utility screen is divided into menu headings and actions.
Five menu headings appear on the Computer Setup Utility screen:
Main
●
Advanced
●
Power
●
Boot
●
Exit
●
Use the arrow keys to select the appropriate heading, then press Enter. Use the arrow (up and
down) keys to select the option you want, then press Enter. To return to the previous screen, press
Esc.
CAUTION:
(F10) changes because the CMOS could become corrupted. It is safe to turn off the computer only after
exiting the F10 Setup screen.
If you do not press F10
before the computer boots to the operating system to access the utility.
Do NOT turn the computer power OFF while the ROM is saving the Computer Setup
F10 before the computer boots to the operating
at the appropriate time, you must restart the computer and again
HP Pro 3120 – Computer Setup (F10) Utilities 11