Computer Setup-Exit; Hp Pro 3125 - Computer Setup (F10) Utilities; Using Computer Setup (F10) Utilities - HP Pro 2110 Small Form Factor Maintenance & Service Manual

Computer Setup—Exit
NOTE:
Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 2-12
Option
Exit Saving Changes
Exit Discarding
Changes
Load Setup Defaults
Discard Changes
Save Changes
HP Pro 3125 – Computer Setup (F10) Utilities
Use Computer Setup (F10) Utility to do the following:
Change factory default settings.
●
Set the system date and time.
●
Set, view, change, or verify the system configuration, including settings for graphics, audio,
●
storage, communications, and input devices.
View settings for processor and memory.
●
Modify the boot order of bootable devices such as hard drives, optical drives, or USB flash media
●
devices.
Run hard drive self-tests.
●
Establish a supervisor password that controls access to Computer Setup (F10) Utility and the
●
settings described in this section.

Using Computer Setup (F10) Utilities

Computer Setup can be accessed only by turning the computer on or restarting the system. To access
the Computer Setup Utilities menu, complete the following steps:
1.
Turn on or restart the computer.
2.
As soon as the computer is turned on, press
system to enter Computer Setup.
NOTE:
press F10
3. The Computer Setup Utility screen is divided into menu headings and actions.
Computer Setup—Exit
Description
Press Enter to exit saving changes.
Press Enter to exit discarding changes.
Press Enter to load setup defaults.
Press Enter to discard changes.
Press Enter to save changes.
If you do not press F10
before the computer boots to the operating system to access the utility.
F10 before the computer boots to the operating
at the appropriate time, you must restart the computer and again
HP Pro 3125 – Computer Setup (F10) Utilities 17