Front I/O Assembly - HP EliteDesk 705 G3 Small Form Factor Maintenance And Service Manual

Front I/O assembly

The front I/O assembly is attached to the front of the chassis with one screw. Push the assembly into the
chassis to remove.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Rotate the drive cage to its upright position.
5. From the front of the computer, remove the Torx T15 screw (1) that secures the assembly to the front of
the chassis.
6. Press the tab on the right side of the assembly (2), and then push the assembly into the computer.
7. Rotate the drive cage to its upright position.
8. Disconnect the cables from the system board as follows:
(1) Blue connector labeled FRONT_USB3.1
(2) Yellow connector labeled USB2
(3) Blue connector labeled FRONT AUD
9. Remove the cables from the clips built into the basepan.
52 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
(Preparation for disassembly on page
(Access panel on page 19).
(Front bezel on page 19).
18).