Table of Contents
Advertisement
Front I/O assembly
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Rotate the drive cage to its upright position.
5.
Cut the plastic tie that secures the longer cable to the power supply.
6.
Disconnect the cables from the system board as follows:
●
Yellow connector labeled FRONT USB
●
Blue connector labeled FRONT USB 3.0
●
Blue connector labeled FRONT AUD
48
Chapter 4 Removal and replacement procedures: Small Form Factor
(Preparation for disassembly on page
(Access panel on page
20).
(Front bezel on page
21).
19).
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ProDesk 400 G2 Small Form Factor and is the answer not in the manual?
Questions and answers