Computer Setup-Boot - HP Pro 2110 Small Form Factor Maintenance & Service Manual

Computer Setup—Boot
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 2-21
Option
Boot-time
Diagnostic
Screen
Boot Device
Priority
ESC: Boot Menu
F9: Diagnostics
F10: Setup
F11: Recovery
F12: Boot from
LAN
28 Chapter 2 Computer Setup (F10) Utility
Computer Setup—Boot
Description
Disables/enables POST diagnostic messages display during boot. Default is disabled.
Allows you to specify which device groups will boot first, second, third, and fourth or to disable any of
the four. Also allows you to set the device boot priority within each group.
1st Boot Device
2nd Boot Device
3rd Boot Device
4th Boot Device
Floppy Group
Boot Priority
CD-ROM Group
Boot Priority
HDD Group Boot
Priority
Network Group
Boot Priority
Allows you to enable/disable the option to press the ESC key to access the Boot menu during computer
startup. Default is enabled.
Disables/enables the F9 Boot Menu prompt message on the logo screen. Default is enabled.
Disables/enables the F10 Setup prompt message on the logo screen. Default is enabled.
Disables/enables the F11 Recovery prompt message on the logo screen. Default is enabled.
Disables/enables the F12 Boot from LAN prompt message on the logo screen. Default is enabled.
Allows you to set the device group boot priority:
● CD-ROM Group
Hard Drive Group
●
● Floppy Group
Network Boot Group
●
NOTE:
MS-DOS drive lettering assignments may not apply after a non-MS-DOS
operating system has started.
Specifies boot device priority within removable devices.
NOTE:
This computer does not support floppy drives.
Specifies boot device priority within CD/DVD drives.
Specifies boot device priority within hard drives.
Specifies boot device priority within bootable network devices.