HP Pro 2110 Small Form Factor Maintenance & Service Manual page 66

Table 5-4
Item
1
2
3
4
NOTE:
You can install a PCI Express x1, x4, x8, or x16 expansion card in the PCI Express x16
expansion slot.
To remove, replace, or add an expansion card:
1. Prepare the computer for disassembly
2.
Remove the access panel
3. Locate the correct vacant expansion socket on the system board and the corresponding expansion
slot on the back of the computer chassis.
4.
On the rear of the computer, a slot cover lock secures the expansion card brackets in place.
Remove the screw from the slot cover lock then slide the slot cover lock up to remove it from the
chassis.
Figure 5-11
5.
Before installing an expansion card, remove the expansion slot cover or the existing expansion
card.
56 Chapter 5 Removal and Replacement Procedures Minitower (MT) Chassis
Expansion Slot Locations
Description
PCI Express x1 expansion slot
PCI Express x1 expansion slot
PCI Express x1 expansion slot
PCI Express x16 expansion slot
(Access Panel on page
Opening the Slot Cover Lock
(Preparation for Disassembly on page
43).
42).