Table of Contents
Advertisement
6 — Configuring frame relay connections
Procedure 6-12 Configuring DE mapping
CONFIG — CONNECT — <endpoint>
DE_MAPPING — DE=CLP* or DE=0 or DE=1
where endpoint is in the format <U;S1/Ddlci> or <U;Ddlci>, and dlci is a value from 16 to
1007, or <N;0/vci>, and vci is a VCI number from 32 to 157
Procedure 6-13 Configuring CLP mapping
CONFIG — CONNECT — <endpoint>
CLP_MAPPING — CLP=DE* or CLP=0 or CLP=1
where endpoint is in the format <U;S1/Ddlci> or <U;Ddlci>, and dlci is a value from 16 to
1007, or <N;0/vci>, and vci is a VCI number from 32 to 157
Procedure 6-14 Configuring EFCI mapping
Select one of the two connection endpoints:
CONFIG — CONNECT — <endpoint>
EFCI_MAPPING — EFCI=FECN* or EFCI=0
where endpoint is in the format <U;S1/Ddlci> or <U;Ddlci>, and dlci is a value from 16 to
1007, or <N;0/vci>, and vci is a VCI number from 32 to 157
6.5
Configuring frame forwarding connection options
The softkey structure for configuring frame forwarding connection options is shown
below.
SHOW_GROUP
The procedures for selecting endpoints, displaying connection information and
disconnecting an endpoint for a frame forwarding connection are the same as those
for a frame relay connection. Refer to section 6.1 for details. Traffic pacing is
enabled by default and cannot be disabled.
6-8
— INTERWORKING — SERVICE_IWF —
— INTERWORKING — SERVICE_IWF —
— INTERWORKING — SERVICE_IWF —
CONFIG
CONNECT <endpoint>
DISCONNECT
TO_ENDPOINT <endpoint>
Speed Touch 591s Technical Practices
SK002120
90-8785-01
February 2001
Advertisement
Table of Contents
