Table of Contents
Advertisement
Procedure 10-11 Configuring the signaling path for trunk
conditioning
1
Enter:
CONFIG — OBJECT — PORT — <U>
2
Specify the channel or channels.
a
b
c
3
Select:
SIGNALING
4
Enter the bit pattern for the signaling path.
a
b
Speed Touch 591s Technical Practices
February 2001
90-8785-01
For a single channel, enter:
<channel_id>
where channel_id is a number from 1 to 24 for a T1 CE port and 1 to 31 for an E1
CE port
For a channel group, enter:
<CGnumber>
where number is the lowest numbered channel in a channel group
For a channel range, enter:
<n1-n2>
where
n1 is the first channel in the range in the CH column
n2 is the last channel in the range in the CH column
To transmit a bit pattern of idle fault signaling, enter:
CODE_1 — <abcd>
where a, b, c, and d are 0 or 1
To transmit a bit pattern of seized fault signaling, enter:
CODE_1 — <abcd>
where a, b, c, and d are 0 or 1
then:
CODE_2 — <abcd>
where a, b, c, and d are 0 or 1
10 — Configuring the T1/E1 CE port
— TRUNK_COND
10-15
Advertisement
Table of Contents
