Table of Contents
Advertisement
5 — Configuring frame relay port parameters
Procedure 5-2 Configuring the interface type
CONFIG — OBJECT — PORT — <U>
Procedure 5-3 Configuring input control leads
1
Enter:
CONFIG — OBJECT — PORT — <U>
2
Select:
a
b
3
Select:
ASSUME_ON or ASSUME_OFF or ACTIVE*
Procedure 5-4 Configuring output control leads
1
Enter:
CONFIG — OBJECT — PORT — <U>
2
Select:
DSR or DCD/I or CTS or TM
3
Select:
a
b
5-4
Note — Every time the interface type is changed, the user port reverts
to the disabled state and must be enabled again. Refer to section 13.3 for
details on how to enable the user port. The default interface type is V.35.
For X.21:
C
For V.35 and V.36/TIA-449:
DTR or RTS
For DSR or TM:
FORCE_ON* or FORCE_OFF or IND_MAINT* (TM output only)
For DCD/I or CTS:
ACTIVE* or FORCE_ON or FORCE_OFF
— OPTIONS — IF_TYPE — V.35* or TIA-449 or X.21
— OPTIONS — CTRL_LEADS — INPUTS
— OPTIONS — CTRL_LEADS — OUTPUTS
Speed Touch 591s Technical Practices
90-8785-01
February 2001
Advertisement
Table of Contents
