Table of Contents
Advertisement
Safety approval for dc systems
The dc source for the system must meet the requirements of a SELV source in
accordance with CSA C22.2 No. 950. The system is intended for use with a SELV
secondary source that is electrically isolated from the ac source, and that is reliably
connected to earth.
United States Federal Communications Commission
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a commercial
environment. This equipment generates, uses and can radiate radio frequency
energy, and if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference, in which case the users will
be required to correct the interference at their own expense.
In the event that repairs are needed to this equipment, contact:
Alcatel CID
810 Commerce Park Drive,
Ogdensburg, NY 13669
(315) 393-9981
Safety approval for dc systems
The dc source for the system must meet the requirements of a SELV source in
accordance with UL1950. The system is intended for use with a SELV secondary
source that is electrically isolated from the ac source, and that is reliably connected
to earth.
CSA NRTL
This equipment is certified by the Canadian Standards Association as meeting the
requirements of UL1950, Safety of Information Technology Equipment (or UL1459,
Safety of Telephone Equipment). CSA is listed by the American Federal
Occupational Safety and Health Administration as equivalent to Underwriters
Laboratories and other American safety testing laboratories under the Nationally
Recognized Testing Laboratories program.
European regulations
This product has been CE marked in accordance with the requirements of European
Directive 93/68/EEC.
This product complies with the requirements of European Directive(s) 73/23/EEC
(LVD), 89/336/EEC (EMC) and 91/263/EEC (TTE).
This equipment must be permanently earthed.
Speed Touch 591s Technical Practices
February 2001
90-8785-01
Mandatory regulations
xvii
Advertisement
Table of Contents
